It’s used to remove the emulsion layer of the stencil for
recycle use. It should not
be permitted to dry on the surface of the screen. It will become
virtually impossible to remove if allowed to dry. Repeated rinsing will
result in excess waste water that must be disposed of as a regulated
waste and will not significantly improve the situation.
Working Instruction
-
a.
Add the powder in some cold water and stir evenly
until the powder has fully dissolved.
-
b.
Clean ink and filler off the mesh.
-
c.
Apply some dissolved solution onto both sides of stencil, soaked for
2-5 minutes, then brush the stencil until the emulsion has been
dissolved.
-
Rinse
off with flush water.
Parameters
Note
-
100g
powder can mix with 4-5L cold water. But if it’s difficult to remove
the emulsion, please reduce the dosage of water; in contrast, please
add the dosage of water.
-
Please flush with water in case of accidental skin
contact.
-
Please ware respirator while using if you can’t stand its pungent
smell.
|
|