|
Step1: Adjust the different specifications of the product
Turn off
the motor, loosen the lock nut supporting plate, the workpiece size regulating
shaft to move out. Unloading the upper die and the lower die, the need for the
upper and lower die, according to the following step2 and step3 to complete the
diameter and height of the adjustment.
Step2:
Adjust the workpiece diameter
Loosen the lock nut supporting plate,
the premise of the press wheel does not touch the head of, (above the head, the
first pressing wheel, adjusting the size of the workpiece axis center of 3.1)
.The first roller is adjusted to the distance from the top of the head about
2mm, the locking nut lock tight to 3 points, at this point to turn the handle to
see if the distance between the second rollers to keep up with the pressure head
is the same as the distance between the first roller and the pressure head, if
the distance between the two rollers to keep up with the pressure head is
relatively large, at this time, we need to use the eccentric shaft to adjust the
distance between the two rollers to keep up with the pressure head, generally,
the first press wheel is closer to the upper pressure head than the second
pressing wheel. (about 0.5mm), this step is a good and fine adjustment screw
slowly inside adjustment, generally to the first round of pressure head distance
is about 0.5--0.8mm, second wheel head distance is about 0.8--1.2mm, at this
time if a wheel distance is not ideal can be adjusted (by an eccentric shaft
this size depends on the effect) after adjusting the lock nut lock.
Step3:
Adjust the height of the workpiece
Loosen the
height adjusting rod nut, adjust the height adjusting screw height, put them in
a jar and lid, will lift the handle into the up position, rotating head height
adjustment screw to just stick the lid and then to increase 1 2mm or so, to
achieve the sealing tank body and the tank cover rotation function, and then
lock the nut can be.
Step4: Test
seal
The above two steps can be carried
out after the test well sealed, open motor switch, put them in a jar and lid,
treading the foot pedal, the right hand to hold the handle in turn the first
roller and the second roller pressure on the head (Note: the wrench handle when
the speed is not too fast, otherwise it will hand to steady, the edge seal
appears choppiness or Flash), when second pressure wheel pressure head back from
around 5--10mm, that is to limit pressure wheel rotation, then release the
pedal, follow the workpiece bottom die in place after the handle drop back, look
at the effect of out products, the effect can be no problem production, if the
result is not ideal and can adjust the eccentric wheel.
|
