|
1. Push the Switch up to turn the Motor ON,
Check whether the machine work well. Make sure There are no
people on the output side of the machine. Comparing the
cables/wires’ diameters with the feeding holes on the machine,
feeding the cables/wires one piece at one time. Before feeding
the cables/wires, please cut off the head of the cables/wires,
to avoid gaps caused to the blades.
2. On the output side, if the cuts on the cables/wires are too
deep, please check below points:
①Please adjust the handles on the input side, screw down or
loose them. (M12 handles)
②Check whether the cables/wires on the right position as you
feeding them.
③Make sure the blades are sharp, if not, polish them with the
oil stone
3. On the output side, if see the plastic (PVC) has been
stripped, but the copper wires can not been disgorged, please
check below 4 points:
①Check whether the springs are loose, if yes, screw down to make
them tighten
②The diameter of the cables/wires are too small, please adjust
the space between the two axises to 0.3-0.6mm.
③If the cables/wires you want to strip are hot, also can not get
the copper wires stripped out.
4. If the cables/wires were Blocked in the axises, please check
below points:
①check if the V-belts are loose.
②If the springs on the press wheels are too tight, loose them.
③There are too much oil on the cables/wires, please wipe it
(make sure the machine is turned off when you wipe the axises) |
