1.45 ° Mitre Clamp is mainly
use for the (man-made and natural), or other similar sheet of 45
stitching. Since its launch, with high quality and innovative ideas,
best-selling home and abroad, welcome customers to purse.
2.When two workpieces are
processed into a 45 edge bevel, then clean the 45 face of workpiece,
evenly coated with adhesive, then put two workpiece of 45 bevel face
assembling together, and the two 45°workpiece fit into a 90 with each
other, use the fixture in plastic extrusion seam stitching.
3.First, put the bottom of
width stone on the fixture work surface which with white rubber, the
side of the narrow stone close to the 90 inside of the fixture.
4.Then two binder lever can be adjusted by adjusting spring device
access to the top position of the workpiece,then
rotating the screw at the top of the binder lever to put pressure in
place to maintain the fixture locked position for a certain time, until
the workpiece fully bonded joints, solid, and
then release the fixture. |